*v 0008
*n code=0043 name="ElevatorOffsetCalculator"
½!¿6tB‹
ơCompleted estimation for commanded vars: speed 1.00 m/s, pitch -20.00 deg, mass-position 4.48 mm. Average elevator angle=2.098600 +/- 0.088320 deg (conf. level 99.90%, sigma: 0.349664 deg).½!¿9tB‹
ơCompleted estimation for commanded vars: speed 1.00 m/s, pitch 20.00 deg, mass-position 4.48 mm. Average elevator angle=-0.855968 +/- 0.097294 deg (conf. level 99.90%, sigma: 0.344083 deg).=O¿³K‹
øContinued flight (after front detection) completed. searchHdgSetting_ switches from 180.000000 degrees to 45.000000 degrees.*n code=0036 name="RudderServo"
]¿re‹
^Rudder uart error - getPosition..serial timeout=O¿d3‚‹
ªFront detected. Continue flight for 1440.000000 seconds on heading 45.000000 degrees.=#¿D%Œ‹
6Beginning ground fault scan=#¿QRŒ‹
qGround fault detected
mA:
CHAN A0 (Batt): -0.004148
CHAN A1 (24V): 0.015050
CHAN A2 (12V): -0.014346
CHAN A3 (5V): -0.039010
CHAN B0 (3.3V): -0.043369
CHAN B1 (3.15aV): -0.045650
CHAN B2 (3.15bV): -0.045455
CHAN B3 (GND): -0.060136
OPEN: -0.014417
Full Scale Calc: 4.765 mA, -1.589 mA*n code=0037 name="ThrusterServo"
Ư¿ªÓ•‹
HInvalid EZ Servo response:"/0@5242"=O¿”´˜‹
øContinued flight (after front detection) completed. searchHdgSetting_ switches from 45.000000 degrees to 180.000000 degrees.Ư¿N»®‹
JgetVelocity uart error serial timeoutƯ¿O»®‹
FThruster uart error: serial timeoutƯ¿Â‡µ‹
JgetVelocity uart error serial timeoutƯ¿Â‡µ‹
FThruster uart error: serial timeout